WeChat ID
aaronpk_tv
#3d
-
The fun thing about 3D printing is being able to make custom mounts and brackets that are useful to approximately 3 people in the world.
This is the old AppleTV remote with the remote for my Yamaha sound bar.
-
This is really well done! All the parts fit perfectly, and the drone even fits with my velcro on the top for the little strobe light. I'm actually using the bottom chamber for the strobe since I don't use the DJI charger brick at all.
My only complaint is I wish the outer shell were a bit thicker all the way around. It's super thin where the extra chamber is (under 1mm), and flexes when I touch it. The side wall next to the controller is a bit thicker (1.6mm) but also flexes. I would have loved for it to be more like 3.6mm all the way around. I might try that myself, but at nearly 24h print time it's not something I'm eager to print again!
-
Print in Place Geared Hinge by E. Soderberg | Download free STL model | PrusaPrinters (www.prusaprinters.org)
-
First attempt at making a snap fit joint so I can make parts that move! It snaps together and definitely will not come out anymore, but also rotates smoothly! Looking forward to some interesting things I can do with this!
-
Thing files for RODE Wireless GO II (GO 2) mic storage clip by mareklew - Thingiverse (www.thingiverse.com)
-
Finally had the first failure of my Prusa Mini #3DPrinter. I was changing the filament and it got stuck on its way out, and then I snapped it trying to pull it out. Seven months is a pretty good run for zero maintenance though!
-
the danger of having a 3D printer is seeing stuff on amazon and saying "I bet I could print that myself" and then doing it.
sometimes this does not make economical sense, such as when the alternative was to spend the $6 for the amazon one. but it is fun.
