34°F

Aaron Parecki

#djimini2

  • Aaron Parecki
    This is really well done! All the parts fit perfectly, and the drone even fits with my velcro on the top for the little strobe light. I'm actually using the bottom chamber for the strobe since I don't use the DJI charger brick at all.

    My only complaint is I wish the outer shell were a bit thicker all the way around. It's super thin where the extra chamber is (under 1mm), and flexes when I touch it. The side wall next to the controller is a bit thicker (1.6mm) but also flexes. I would have loved for it to be more like 3.6mm all the way around. I might try that myself, but at nearly 24h print time it's not something I'm eager to print again!
    Portland, Oregon • 63°F
    like
    #drone #djimini2 #3dprinting #3d #make
  • Aaron Parecki
    If I haven't crashed my drone yet, does that mean I'm not being adventurous enough?

    Some shots from our 20-hour layover in Hawaii
    Portland, Oregon, USA • 72°F
    likes 3 replies
    #hawaii #drone #djimini2
  • Aaron Parecki
    I had such a great time flying my drone around Iceland! The DJI Mini 2 is such a delight to use! I'm still learning what makes a good drone shot, but I stitched together this highlight reel of some of my favorites!
    Portland, Oregon • 50°F
    likes 2 replies
    #djimini2 #djimini #drone #video
  • Aaron Parecki
    Successfully did not crash my drone on my first drone flight and first drone flight in -6°F/-21°C 😇

    My phone battery gave up in the cold before the drone battery died.

    Not gonna claim this photo is going to win any awards, but I'm still considering this a success.
    Rovaniemi FIN
    likes 2 replies
    #drone #djimini2