Aaron Parecki

Yeah! I highly recommend the Pilot Institute course! That's really the only thing I studied before the test: https://pilotinstitute.com/course/part-107-remote-pilot/?affcode=245841_o4stdmp5

oops, no https.

http://resolvecon.com/

I mean then it sounds like maybe you're looking for something else entirely? No need to dismiss an entire community of people working together to build things because it doesn't match up with what you want 🤷‍♂️

There's a lot of new stuff if you look past the home page. I agree there are some problems with how we've described things, and I'd like to fix that, but it feels like you're coming to a pretty quick judgment without a lot of context.

Found a spot on the floor next to me for my bike!

✅ Easy leg is done: home to the PDX Amtrak station

The answer is "very easy"

okay fine you win

I was considering that! I don't have room for my Mevos but if you can bring some.... !

Hey it wasn't that bad, it did 1080i!

Sure you don't want me to bring another ATEM?

You're close enough we should try to get a connection over the air some time! 👋 W7APK

yeah it depends on the overall goal really. Scuttlebutt has done some interesting things with a non-federated and offline-first approach to decentralized comms https://scuttlebutt.nz

i meant general problems, sorry

maybe I misinterpreted the specific problems with the fediverse that you're referring to then.

I'm trying to find a good reference, this one talks about some of the problems, which Mastodon has for the same reasons: http://natdudley.com/blog/twitter-ux-and-bullying/

i mean doesn't that kind of exactly demonstrate your earlier point about the twitter/mastodon interaction model 😂

the original mention of indieweb was sufficiently vague that I don't blame you for conflating it with mastodon, but there's a lot more to draw inspiration from than just what mastodon did. for example, i'm not even writing this on twitter, i'm writing it on my own website.

you're talking about Mastodon/fediverse specifically, right? because indieweb encompasses a lot more than just that model

This is really well done! All the parts fit perfectly, and the drone even fits with my velcro on the top for the little strobe light. I'm actually using the bottom chamber for the strobe since I don't use the DJI charger brick at all.

My only complaint is I wish the outer shell were a bit thicker all the way around. It's super thin where the extra chamber is (under 1mm), and flexes when I touch it. The side wall next to the controller is a bit thicker (1.6mm) but also flexes. I would have loved for it to be more like 3.6mm all the way around. I might try that myself, but at nearly 24h print time it's not something I'm eager to print again!

cause I don't like my electronics to look like they are going to attack me in the middle of the night 🤷‍♂️