Got any docs on using it to make a layer 2 vpn? I think that's ... • Aaron Parecki

Aaron "wash your hands" Huslage https://twitter.com/huslage • Jun 25
@aaronpk you should check out @Tailscale for your vpn needs on the ATEM Mini project. It puts everyone on the same network with very little set up.

Got any docs on using it to make a layer 2 vpn? I think that's what I'm looking for.

Portland, Oregon • 69°F

Wed, Jun 24, 2020 9:30pm -07:00

5 replies
Have you written a response to this? Let me know the URL:
- apenwarr twitter.com/apenwarr
  
  This would provide basically that: tailscale.com/kb/1019/subnets but if the networks you visit each have different subnets to advertise, you’d have to approve them separately for security reasons.
  
  Thu, Jun 25, 2020 3:56pm +00:00 (via brid-gy.appspot.com)
- Aaron Parecki twitter.com/aaronpk
  
  I'm trying to create a "travel kit" which will connect back to a vpn server and make any device on the remote end available from the network on the vpn server end. Ideally with instructions that can be followed by someone with no networking experience.
  
  Thu, Jun 25, 2020 5:37am +00:00 (via brid-gy.appspot.com)
- David Crawshaw twitter.com/davidcrawshaw
  
  Hi. Tailscale is built on WireGuard, which I would tend to call layer 3. Could you be more specific about what you're aiming to do?
  
  Thu, Jun 25, 2020 5:07am +00:00 (via brid-gy.appspot.com)
- Aaron Parecki twitter.com/aaronpk
  
  There's, um, a distinct lack of actual documentation on those doc pages. They seem to be marketing copy about potential uses.
  
  Thu, Jun 25, 2020 5:01am +00:00 (via brid-gy.appspot.com)
- Aaron "wash your hands" Huslage twitter.com/huslage
  
  Lots of docs here. tailscale.com/kb/Solutions
  
  Thu, Jun 25, 2020 4:36am +00:00 (via brid-gy.appspot.com)

Posted in /replies using indigenous.abode.pub/ios